4/6/2023 0 Comments Ultimaker cura manualThis is the most crucial part off the print. Wait for the 3D printer to initialize and for the first layer to print. Go to the main status overview menu and select the file you want to print. Place the USB stick in the USB port on Ultimaker S5. Wait for the Ultimaker S5 to heat up print core 1 and to load the material into the print head.Ĭonfirm when the new material extrudes consistently from print core 1.Īpply a thin layer of glue to the glass build plate to ensure reliable adhesion. Insert the end of the material into feeder 1 and gently push it until the feeder grips it and the material is visible in the Bowden tube. Select the material type manually, choose PLA or any other material that you are printing with. Load the material on the material spool 1 with the material in a counter-clockwise direction, and guide the end of the material through the hole in the material guide. Place the material guide into the spool and insert the tip of the filament through the bottom opening. Then select Change filament or introduce filament and follow the screen instructions. In the main screen press the printer icon then the material button under the icon “AA.0.4” Once you configured all the settings, you can preview the printing time of your model and export the Gcode t the SD card of the 3D printer. In general, Skirt is preferred, unless the base of your model is very thin or unstable. Raft: option uses a larger, multi-layered base to improve part adhesion. Skirt: Used to prime the hot end to ensure that sufficient material is being extruded prior to start of the print.īrim: Option that can improve printed part adhesion to the print surface by increasing the surface area of the first layer. If overhangs are greater than 45 degrees (with respect to the vertical), they will need support. Press SHIFT for rotating in 45 degrees increments.ĭUPLICATE: Add more instances of your model.Ĭhoose the machine that you are going to use.Ĭhange the view mode to “layer view” to visualize the print layers of your model and for checking possible problems.įor Ultimaker S5 choose one the the following default settings:ĭetermine whether you need support structures or not. While dragging, the rotate angle is displayed next to the mouse pointer. ROTATE: Drag on of the rings along the axis. Make sure to tick the “Uniform Scaling” box to preserve the proportions. SCALE: Set a specific dimension for the X,Y or Z axis or set a scale percentage in the tool panel. MOVE: Clicking one of the arrow heads allows the model to be moved on one axis at a time. STL directly into Cura.Īdjust the model before printing if needed by using the transformation tools on the left side of the screen. Navigate and find your file on the computer and open it. Load your STL file in Cura Lulzbot (green) by clicking on the icon “LOAD MODEL” located at the upper left of the window. Use one of the computers in #823 and open the green CURA Software using the icon located on the menu at the bottom of the screen.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |